The 3D Markup Dimension commands are called from either the Linear, Radial, Angular, or Smart Edge Dimension menus located on the 3D Document Toolbar.
Selecting a Point
When you choose a command that requires you to select points, red dots appear on the model that indicate where selections can be made. (If you do not see the red dots, you may want to go to the 3D Viewer Settings page and select the Points Visible on Picking check box.)
Red cross-hairs indicate when the pointer is properly positioned over a point. A yellow dot indicates that you have successfully selected a point.
Selecting an Edge or Arc
Some 3D Markup Dimension commands, such as Edge Length and Arc Diameter, require you to select an edge or arc that already exists on the model. When the pointer is properly positioned over an edge or arc, the line or arc is highlighted.
3D Markup Dimensions
Calculate menu (found on the Assembly pane):
Volume - Measures the volume of a part. How...
Surface - Measures the surface area of a part. How...
Center of Mass - Lists the X, Y, and Z coordinates of the center of mass of a part. How...
Extent Box - Draws a box around a part and measures the part along the X-, Y-, and Z-axes. How...