Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Radial Dimensions . . .
 Measure an arc diameter
  1. Open the Radial menu on the 3D Document toolbar. (How? Click the drop-down arrow to the right of the Radial icon. You should see a drop-down menu listing the available commands.)
  2. Click Arc Diameter.
  3. Optional: Navigate to or enter a hyperlink to a file or a ???.
  4. Position your pointer over the arc you want to measure in the model. The arc is highlighted when the pointer is properly positioned for selection.
  5. Click on the arc.
  6. Drag the label into position and click once.

Note

If you want to add several of the same type of markup, you may select the Lock tool checkbox that appears when you select a markup command. This will allow you to keep adding the same type of markup to the scene until you click Stop.

 Measure an arc diameter
  1. Open the Radial menu on the 3D Document Toolbar. {How? Click the drop-down arrow to the right of the Radial icon. You should see a drop-down menu listing the available commands.)
  2. Click Arc Radius.
  3. Optional: Navigate to or enter a hyperlink to a file or a ???.
  4. Position your pointer over the arc you want to measure in the model. The arc is highlighted when the pointer is properly positioned for selection.
  5. Click on the arc.
  6. Drag the label into position and click once.

Note

If you want to add several of the same type of markup, you may select the Lock tool checkbox that appears when you select a markup command. This will allow you to keep adding the same type of markup to the scene until you click Stop.

 Measure a circle by three points
  1.  Open the Radial menu on the 3D Document toolbar. (How? Click the drop-down arrow to the right of the Radial icon. You should see a drop-down menu listing the available commands.)
  2. Click Circle by Three Vertices. Red dots designate available vertices on the model.
  3. Optional: Navigate to or enter a hyperlink to a file or a ???.
  4. Click three vertices on the model. Crosshairs indicate when the pointer is properly positioned over a point.
  5. Drag the label into position and click once.

Note

You can choose to show only the arc that runs through the three points by right-clicking the label and selecting Draw Arc from the context menu.

 If you want to add several of the same type of markup, you may select the Lock tool checkbox that appears when you select a markup command. This will allow you to keep adding the same type of markup to the scene until you click Stop.

Markup context menu

 

  • No labels