This is for 11.1..0 which is to be released in September.
# When performing a pipe length measurement, there's a new check box that is checked by default.
!image-20150714162205.png|thumbnail!
# With this checked, a user can select the beginning arc of a pipe and then the end arc of a pipe and SpinFire will attempt to automatically traverse the pipe for length measurement following all the straights and bends. // !image-20150714162517.png|thumbnail!
#*
Before a user had to tediously select each arc from the beginning to the end. For long pipes this took a long time and if one made a mistake they would have to start over. // !image-20150714163032.png|thumbnail!
See also Measurement Tips.
